Explainer video · TEMISA
How a centrifugal pump is repaired: 9 steps, from teardown to alignment
Short answer
A centrifugal pump is repaired in nine steps, always in the same order. After the call to TEMISA it is uncoupled and torn down, the impeller and volute are inspected, the wear rings are measured, seals and bearings are replaced, the impeller is balanced, and the pump is assembled and tested. The most important step is the last one: alignment with the motor, because bad alignment destroys seals and bearings.
Key points
- The pump is uncoupled from the motor and torn down.
- Impeller and volute are inspected for wear and cavitation.
- If the wear ring clearance has grown, the pump loses efficiency.
- Mechanical seals and bearings are replaced and the impeller is balanced.
- The key step is alignment with the motor, with the pump installed.
Transcript
How is a centrifugal pump repaired? In 9 steps, always in the same order. And the most important one happens at the end, with the pump already installed. 1. You call TEMISA and we check your pump. 2. It is uncoupled and disassembled. 3. The impeller and volute are inspected for wear and cavitation. 4. The wear rings are measured. If the clearance grew, the pump loses efficiency. 5. The mechanical seals are replaced. 6. The shaft is checked and the bearings are replaced. 7. The impeller is balanced. 8. It is assembled and tested. 9. The most important: alignment with the motor. Bad alignment destroys seals and bearings in a short time. It's not the pump, it's how it's aligned. Comment PUMP and we'll tell you what to check on yours. TEMISA: over 70 years in industrial repair, ISO 9001:2015, CFE LAPEM certificate and EASA member. Contact: ventas@temisa.mx, +52 33 3614 2460.
Frequently asked questions
What is the most important step when repairing a centrifugal pump?
Alignment with the motor, with the pump installed. Bad alignment destroys seals and bearings quickly.
Why are the wear rings measured?
If the clearance has grown, water recirculates inside the pump and it loses efficiency.
What is checked on the impeller and volute?
Wear and cavitation. The impeller is then balanced before the pump is assembled.
Does TEMISA repair centrifugal pumps?
Yes, the hydraulic end and the motor, at the Tlajomulco shop, and aligns the set on site. Email ventas@temisa.mx or call +52 33 3614 2460.
Related
Video with images and narration generated with AI.
Request a quotation by email: ventas@temisa.mx. Phone: +52 33 3614 2460.
More videos
- Medium voltage motor rewinding after a ground fault
- Industrial electric motor repair for a volute pump
- Dynamic balancing services for electric motors, ISO 21940
- Squirrel cage rotor repair for broken bars
- Locomotive traction motor repair: the commutator
- Emergency motor repair, on site or in the shop
- Induction motor slip: why it never reaches 1,800 rpm
- Motor starting current: 6 to 7 times rated, for seconds
- Burnout oven in a rewind: keep the core under 360 °C
- Synchronous motor and power factor: a motor that supplies reactive power
- High megger, damp motor: what the polarization index shows
- Motor running hot: 10 extra degrees, half the life
- Motor hipot test: why a 4,160 V motor gets 9,320 V
- Form-wound coil surge test: IEEE 522
- How is a rotor balanced? 9 steps, from mounting to report