Explainer video · TEMISA
How a rotor is balanced: 9 steps in the same order
Short answer
A rotor is balanced in nine steps. It is received at the shop, cleaned and inspected, mounted on the balancing machine on its own journals, spun to balancing speed, and sensors measure vibration in two planes. The most important part is calculating how much weight and at what angle in each plane. Then weight is corrected, the result is checked within tolerance and it is delivered with its report.
Key points
- The rotor is mounted on the balancing machine on its own journals.
- It is spun to balancing speed and vibration is measured in two planes.
- The machine calculates how much weight and at what angle in each plane.
- Weight is added or removed at that point and the rotor is spun again.
- It is delivered with its balancing report within tolerance.
Transcript
How is a rotor balanced? In 9 steps, always in the same order. And the most important one isn't removing weight, it's knowing where. 1. You call TEMISA and we receive your rotor at the shop. 2. The rotor is cleaned and inspected. 3. It is mounted on the balancing machine on its own journals. 4. It is spun at balancing speed. 5. Sensors measure vibration in two planes. 6. The most important: the machine calculates how much weight and at what angle in each plane. 7. Weight is added or removed at that point. 8. It is spun again until it is within tolerance. 9. It is delivered with its balancing report. It's not the weight, it's the angle. Comment BALANCING and we'll tell you what to check on your equipment. TEMISA: over 70 years in industrial repair, ISO 9001:2015, CFE LAPEM certificate and EASA member. Contact: ventas@temisa.mx, +52 33 3614 2460.
Frequently asked questions
What matters most when balancing a rotor?
Knowing where: the calculation of how much weight and at what angle in each plane. It is not the weight, it is the angle.
Why measure in two planes?
A long rotor can be unbalanced at each end; two planes correct both.
What does the balancing report include?
Readings before and after and the residual left within tolerance.
How heavy a rotor can TEMISA balance?
Rotors up to 15 tons at the Tlajomulco shop. Email ventas@temisa.mx or call +52 33 3614 2460.
Related
Video with images and narration generated with AI.
Request a quotation by email: ventas@temisa.mx. Phone: +52 33 3614 2460.
More videos
- Medium voltage motor rewinding after a ground fault
- Industrial electric motor repair for a volute pump
- Dynamic balancing services for electric motors, ISO 21940
- Squirrel cage rotor repair for broken bars
- Locomotive traction motor repair: the commutator
- Emergency motor repair, on site or in the shop
- Induction motor slip: why it never reaches 1,800 rpm
- Motor starting current: 6 to 7 times rated, for seconds
- Burnout oven in a rewind: keep the core under 360 °C
- Synchronous motor and power factor: a motor that supplies reactive power
- High megger, damp motor: what the polarization index shows
- Motor running hot: 10 extra degrees, half the life
- Motor hipot test: why a 4,160 V motor gets 9,320 V
- Form-wound coil surge test: IEEE 522
- How is a centrifugal pump repaired? 9 steps in order