Explainer video · TEMISA
How a burned-out electric motor is rewound: 9 steps in the same order
Short answer
A burned-out motor is rewound in nine steps. After the call to TEMISA the winding data is recorded, the old insulation is burned out at a controlled temperature and the core test is done, which is the most important step. Then every slot is insulated, coils with the same turns, wire size and pitch go in, wedges and connections are fitted, it is varnished and baked, and final tests are run.
Key points
- Turns, wire size, pitch and connection of the original winding are recorded.
- The old insulation is burned out at a controlled temperature.
- The core test looks for shorted laminations before any wire goes in.
- The new coils have the same turns, wire size and pitch.
- Varnish, bake and tests for resistance, insulation and high voltage.
Transcript
How is a burned-out electric motor rewound? In 9 steps, always in the same order. And the most important one happens before a single wire goes in. 1. You call TEMISA and we check your motor. 2. The winding data is recorded: turns, wire size, pitch and connection. 3. The old insulation is burned out at a controlled temperature. 4. The most important: the core test. If there are shorted laminations, they heat up and burn the new winding. 5. Insulation goes into every slot. 6. The new coils go in, with the same turns, wire size and pitch. 7. Wedges, ties and connections. 8. Varnish and bake, so it becomes one single piece. 9. Final tests for resistance, insulation and high voltage. It's not the wire, it's the core. Comment REWIND and we'll tell you what to check on your motor. TEMISA: over 70 years in industrial repair, ISO 9001:2015, CFE LAPEM certificate and EASA member. Contact: ventas@temisa.mx, +52 33 3614 2460.
Frequently asked questions
What is the most important step when rewinding a motor?
The core test. Shorted laminations heat up and burn the new winding.
Why is the winding data recorded?
So the new winding has the same turns, wire size, pitch and connection as the original.
Which tests are run at the end?
Resistance, insulation and high voltage before the motor is delivered.
Does TEMISA rewind electric motors?
Yes, low and medium voltage, at the Tlajomulco, Jalisco shop. Contact ventas@temisa.mx or +52 33 3614 2460.
Related
Video with images and narration generated with AI.
Request a quotation by email: ventas@temisa.mx. Phone: +52 33 3614 2460.
More videos
- Medium voltage motor rewinding after a ground fault
- Industrial electric motor repair for a volute pump
- Dynamic balancing services for electric motors, ISO 21940
- Squirrel cage rotor repair for broken bars
- Locomotive traction motor repair: the commutator
- Emergency motor repair, on site or in the shop
- Induction motor slip: why it never reaches 1,800 rpm
- Motor starting current: 6 to 7 times rated, for seconds
- Burnout oven in a rewind: keep the core under 360 °C
- Synchronous motor and power factor: a motor that supplies reactive power
- High megger, damp motor: what the polarization index shows
- Motor running hot: 10 extra degrees, half the life
- Motor hipot test: why a 4,160 V motor gets 9,320 V
- Form-wound coil surge test: IEEE 522
- How is a centrifugal pump repaired? 9 steps in order
- How is a rotor balanced? 9 steps, from mounting to report